Here’s what you’ll needed:
-
Gentle shampoo, such as Pure Shampoo
-
Conditioner
-
Shine spray, usch as Luster Mist
-
Wide-tooth comb, such as the Eco Comb
-
Towel
-
Cold or lukewarm water
-
T-pins (for HRS)
-
Optional: Plastic wig cap (to protect the styling head)
Step 1: Detangle
Before washing, gently detangle the hair using a wide-tooth comb. Start at the tips and work your way up to the roots to avoid damage.
Step 2: Pre-Wash Setup
Fill a sink or basin with cold to lukewarm water and add a small amount of Moxi Loxi Pure Shampoo.
Step 3: Submerge
Gently submerge the wig in the water, avoiding twisting or wringing to prevent fiber damage. Be extra gentle with the lace front.
Step 4: Shampoo
Use your fingers to gently distribute the shampoo, being cautious not to tangle the hair. For the cap/base, lightly press the shampoo through without scrubbing.
Step 5: Rinse
Rinse the wig in cold or lukewarm water until the shampoo is completely removed.
Step 6: Condition
Apply a generous amount of conditioner, focusing on the mid-shaft to ends. Avoid the wig cap/base. Let it sit for 3 to 5 minutes before rinsing.
Step 7: Rinse Again
Thoroughly rinse the wig in cold or lukewarm water.
Step 8: Towel Dry
Gently pat the wig dry with a towel. Do not wring or twist.
Step 9: Detangle
Gently comb with a wide-tooth comb or brush with a detangling brush. Place the wig on a styling head (on a stand), part the hair as desired, and secure with T-pins if needed. Make sure the lace, hair, and cap are not tucked under.
Step 10: Air Dry
Place the wig on a styling stand and allow it to air dry completely or approximately 70% depending on the desired style. For curly textures, scrunch and use recommended products.
Step 11: Final Styling
Once dry, spray in Luster Mist and style your wig as you wish using a wide-tooth comb for best results.
By following these steps, you’ll maintain the natural look and feel of your human hair wig or hair replacement system, prolonging its lifespan and ensuring it always looks its best.